1967 Pro Street Nova
1967 Pro Street Nova
This is a brand new very high high pro street build that we have done from scratch. The car is 95% finished but due to unforeseen circumstances, our customer has decided to list it for sale.
It is very difficult to describe completely what has gone into this build. Our customer wanted something that he could drive on the street but would also be an extreme show quality build with a ton of power on pump gas.
This is a tube chassis car with a 100% steel body.
632” Blown Pump Gas BBC built by Beck Racing Engines. Made 1095hp and 1050lbs-ft of torque on 91 octane pump gas w a hydraulic roller cam.
Dart Block w Dart Show Polished Heads
The Blower Shop Billet 10-71 Supercharger
Big Stuff 3 Electronic Fuel Injection
Nitrous Oxide Stainless Plate kit (Not Hooked Up) w purge
MSD Ignition
Lemons Headers
Rossler TH400 transmission w 10” converter
Fabricated Sheetmetal Ford 9” rearend ceramic coated and polished
Strange Alumimun center w 3.50 gear and 40 spline axles
4 wheel wilwood disc brakes
Moly 4 link/wishbone suspension ceramic coated and polished
Strange Coilovers
M/T 33x18.5 ET Street Tires
Rectangular tube frame up to the firewall
Smith Racecraft round tube moly front end
Fully welded and smoothed firewall, custom inner fenders, and factory core support w incredible paint and detail.
Aeromotive 20 gallon aluminum fuel cell w Aeromotive in tank EFI pump and fuel system
Dual Optima Batteries
Full halon safety system installed.
Custom mounted functioning rear factory decklid.
Factory steel cowl hood that is a work of art cut, welded, and molded for the supercharger.
Smoothed factory dash w autometer gauges and nitrous command center.
Dual polished 10” nitrous bottles mounted in between the wheel tubs.
Full cage w swing outs on both sides.
Paint and Bodywork performed by Jack Crowe. Absolutely incredible lazer straight black paint that is miles deep.
Far too much to list it just goes on and on.
One of the finest examples of a radical 67 pro street nova that you will find.
Again at this point the car is 95% finished.
The seats have been recovered and mounted in the car. I have a new black factory headliner and bows that needs installed along w carpet and door panels.
We have a custom made 3.5” full exhaust system mocked up w Borla XR1 mufflers. Exhaust needs welded and sent out for ceramic coat and polish.
There are zero miles on the car. The engine was run on the dyno and started after install (have video).
Over $250k and countless hours hours invested. Looking to get half of that back out of the car
Seller Info:
Canton, OH
Jason Pratt https://www.facebook.com/jason.pratt.12532
Jason Pratt https://www.facebook.com/jason.pratt.12532
Comments
Post a Comment